We produced and delivered a plastic shredding recycling line for GZ Media, the lbiggest vinil plate producer in the world. The recycling plant is used for crushing bad plastic plates and technological plastic waste.
The operator throws the waste on the input belt conveyor, which transports it to
the shredder S1 / 350 1200. This is a single-shaft shredder. The rotor is equipped with prismatic knives. The knives have four blades. After blunting one, the knives turn. The waste is pushed by hydraulic pushing device on the rotor. Under the rotor is the sieve. The shredder is resistant to small hard dirt (M 6 screw, small stones, sheets, fittings, ...). It is able to process large blocks of material.
Pre-crushed waste (size approx. 50 mm, which is a suitable for the subsequent mill) falls into the hopper of the angled belt conveyor. It transports pre-crushed waste to the mill G 400/600. Above the conveyor is a belt magnetic separator which separates the steel.The knife mill is a high-speed machine. Crushing is performed by obliquely mounted knives on a rotating rotor compared to obliquely mounted stator knives. This ensures an oblique cut. The crumb/regranulate is so high quality and with the minimum possible amount of dust. The size of the regranulate is 8 mm.
The crumb is transported by a transport blower. It continues through the pipeline to the cyclone, which is installed on the frame. The crumb falls freely to the octabin.
